i-spraywash

i-spraywash covers the surfaces with active and intelligent foam faster than otherapplication systems. The combination of the concentrated green surfactant-based tablets s and the specially designed foam nozzle, creates a thin layer of high-cling foam, covering 1 m2 in only 1 second.

The thin layer of foam comprises a large proportion of microbubbles that provide a highdegree of coverage of the entire surface, providing a more persistent and effective coveragethan conventional macrobubble foams typical of most foamers in the market.When working with thin, light small-bubble foams, there is less foam runoff on vertical surfaces due to gravity.That’s why we say, “less is more”.

You can cover the surfaces faster, with less chemical and less waste (from heavy foam runoff) on the floor. This in turn enables faster rinsing with much lower volumes of rinse water.

i-spraywash is designed to improve the foam cleaning known for many years. Conventional foamers are heavy, based on liquid chemicals and they have a ”centralized spray pattern”, providing heavy and lots of foam on a small area. Most of this foam runs down fast from the vertical surface, ending up on the floor.

With i-spraywash you do get less foam, but this is part of the innovation and why i-spraywash is a new way of cleaning. If your dosing of the tabs is correct, you will clean with a nice, thin layer of active foam in a faster, greener and safer way. When spraying with the i-spraywash green surfactant based-foam, you will have a broaderspread of a thin filmed foam, which provides longer contact time. The heavier, and larger thebubbles in the foam are, the faster it will run down to the floor- this is the case with regular, conventional foams.

i-spraywash is a new way of thinking foam cleaning. REMEMBER: It’s only the foam in contact with surface that’s doing a cleaning job!

You can tell if you look closely to the surface. If you use the CleaningTab 9 or CleaningTab 12 you can even feel it with your fingers when touching the sprayed surface.

For instance, if you spray with the CleaningTab 9 (daily cleaning in most environments), you should be able to feel the surfactants between your fingers (feels like soap).

With i-spraywash you only have a contact time of 2-5 minutes. How long the foam is active and wet on the surface, depends on the dosing on the surface and the environment where it’s used (temperature, humidity etc.).

If the dosing is a bit low, the active foam tends to dry out faster. If you experience the surface is “dried out” before you get back to rinse, it would be better to clean in smaller “zones”, for instance cleaning one shower block at the time.

If you experience that the foam has dried out on the surface, you simply just rinse with water. If needed you might need to scrub with i-fibre, an ordinary cleaning pad or for instance with i-scrub 21B.

First, it’s all about moving the hand fast when spraying with i-spraywash. When used correctly, you should be able to foam (spray) 1 m2 in just one second, even down to 0,66 seconds when really experienced.

Secondly, it’s the best to spray from the bottom to the top, and work from side to side.Start down in one corner, work you way to the other side and the move up and do the same again. Once you’ve learned this you will discover how fast for instance a shower block is cleaned.

When rinsing with water it’s the opposite. Start from the top, spray from one side to the other and then move down and repeat.